【Reducing the Resource Use】Getting Rid of Material Waste

2015.02.17

Resolving Color Inconsistency by Blending System

The blending system always has the risk of the problem of color inconsistency. We will address the issue...

Resolving Color Inconsistency by Blending System
  • Getting Rid of Wasted Energy
  • Getting Rid of Material Waste
  • Improvement of Surface Quality & Value
  • Resolving Color Variation

2014.10.09

Shortening Set-Up Times during Material Changes

Shortening set up times can increase output, and reduce costs. Shorter setups save “time”, “energy...

Shortening Set-Up Times during Material Changes
  • Getting Rid of Wasted Energy
  • Getting Rid of Material Waste
  • Shortening Set Up Times
  • Getting Rid of Material Waste
  • Lowering Cycle Times
  • Lightening Part Weights
  • Higher Dimensional Precision
  • Getting Rid of Material Waste
  • Lowering Cycle Times
  • Lightening Part Weights
  • Higher Dimensional Precision

2014.03.13

Combined Trexel Technologies and 3M Revolutionize Lightweighting of Plastics; 20% Density Reduction Proven with Molded Auto Parts

The Trexel MuCell® microcellular foam injection molding process combined with 3M technologies provides uniq...

Combined Trexel Technologies and 3M Revolutionize Lightweighting of Plastics; 20% Density Reduction Proven with Molded Auto Parts
  • Getting Rid of Material Waste
  • Lowering Cycle Times
  • Lightening Part Weights
  • Higher Dimensional Precision

2013.12.17

MuCell® Microcellular Foaming Technology for the Injection Molding Industry: The most significant plastics processing innovation in the last 20 years

The MuCell® microcellular foam injection molding process for thermoplastics materials provides unique desig...

MuCell® Microcellular Foaming Technology for the Injection Molding Industry: The most significant plastics processing innovation in the last 20 years
  • Getting Rid of Material Waste
  • Lowering Cycle Times
  • Lightening Part Weights
  • Higher Dimensional Precision

2013.12.17

Microcellular Injection Molding at K2013

In this document, I will report about microcellular injection molding technology at K2013...

Microcellular Injection Molding at K2013
  • Getting Rid of Material Waste
  • Lightening Part Weights

2013.10.15

Achieve Green Molding (2) --- The Solution of the eliminating Material Waste

As every final product requires various material and color with each molding, different combination of...

Achieve Green Molding (2) --- The Solution of the eliminating Material Waste
  • Getting Rid of Material Waste

2013.10.15

Toward “Doubling Wealth, Halving Resource Use” in molding factories (2) --- Is the waste of resource in molding factories is so huge?

if factor4 is feasible, that means the current resource efficiency of most molding factories is below 25%...

Toward “Doubling Wealth, Halving Resource Use” in molding factories (2) --- Is the waste of resource in molding factories is so huge?
  • Getting Rid of Wasted Energy
  • Getting Rid of Material Waste
  • Green Molding in General

2013.09.27

Achieve Green Molding (1) --- Self Control Feature; iplas

We, Matsui, propose “factor4” as a primary target in molding factories. As a partner for…

Achieve Green Molding (1) --- Self Control Feature; iplas
  • Getting Rid of Wasted Energy
  • Getting Rid of Material Waste
  • Green Molding in General

PAGE TOP